Our Notes: This guitar combo amp was recently overhauled by a professional amp technician - completely cleaned, tightened up, and all brand new tubes (4 EL-84s, 3 12AT7s). It sounds amazing. UPDATE: It has also been totally re-capped - all new capacitors including 2 'safety' caps.
Revered by blues, country, and rock players alike, these true all-tube amps span the tonal landscape from vintage to contemporary with ease. These amps are drenched in the tone that can only come from the combination of three 12AX7 and four EL84 tubes. Add features like 3-band EQ, footswitchable dual channels, Presence control and reverb and you have one of the most versatile amplifiers on the market.
For controlled strength and clear sound.
Delivers robust audio projection.
Offer consistent sound output. Master reverb and an effects loop help create a custom sound.
Includes bass, middle and treble for a dynamic listening experience. Boost switch allows additional control.
On a clean channel lets you select an optimal volume level.
Along with 4 EL84 tubes for distinctive sound quality.
With a classic tweed covering for a stylish look.
Allow easy operation (footswitch not included).
POWER AMPLIFIER SECTION | Four 6BQ5/EL84’s with 12AX7 driver |
---|---|
RATED POWER & LOAD | 30 watts RMS into 16 or 8 ohms |
POWER @ CLIPPING (TYPICALLY) | (5% THD, 1 kHz, 120 V AC line) 30 watts RMS into 16 or 8 ohms (Bias must be reduced to measure) |
FREQUENCY RESPONSE | +0, -2 dB, 50 Hz to 15 kHz, @ 20 watts RMS into 16 ohms |
HUM & NOISE | Greater than 80 dB below rated power |
POWER CONSUMPTION | 150 watts, 50/60 Hz, 120 VAC (Domestic) |
PREAMP SECTION | Two 12AX7’s The following specs are measured @ 1 kHz with the controls preset as follows: Pre & Post (lead) @ 0 Reverb Level @ 0 Bass & Treble EQ @ 12 Middle EQ @ 0 Channel Select Out Boost Switch Out Nominal level is with Input Gain @ 6. Minimum level is with Input Gain @ 12. |
PREAMP NORMAL INPUT | Impedance: Very high Z, 470 K ohms |
LEAD CHANNEL | (Post Gain @ 12): Nominal Input Level: -40 dBV, 10 mV RMS Minimum Input Level: -70 dBV, 0.3 mV RMS |
NORMAL CHANNEL | (Post Gain @ 12): Nominal Input Level: -40 dBV, 10 mV RMS Minimum Input Level: -70 dBV, 0.3 mV RMS |
EQUALIZATION | (Lead and Normal Channels) Custom bass, middle, and treble passive-type EQ |
EFFECTS SEND | Load Impedance: 1 K ohm or greater Nominal Output Level: -6 dBV, 0.5 V RMS |
EFFECTS RETURN | Impedance: High Z, 2 M ohms Designed Input Level: -6 dBV, 0.5 V RMS (Switching jack provides Effects Send to Effects Return connection when not used.) |
EXTERNAL FOOTSWITCH FUNCTION | Jack 1: Reverb Defeat (when reverb control is raised), Tremolo on/off Jack 2: Normal/Lead Channel Select (when Lead activated), Boost on/off |
WEIGHT | 46.7 lbs. |